300CE (124.050) L6-3.0L (103.983) (1989)
/l6-3.0l_(103.983)/Page-1979012.png)
31. Insert drive shaft (11) with boaring flange cap (4a) into pump housing (2a). At the same time turn shaft carefully until the eccentric (arrow) of the
drive shaft can be pushed into the bearing sleeve (5f).
32. Fasten bearing flange cap (4a) with 8 screws MS (4c).
Tightening torque: 10 Nm.
33. Push rotor onto the drive shaft so that the chamfer on the inside diameter (arrow) points towards bearing flange cap (4a).
34. Mount new locking ring (11a). The locking ring must seat correctly in the groove (arrow) of the drive shaft.
