300CE (124.051) L6-3.0L (104.980) (1990)
/l6-3.0l_(104.980)/Page-2310005.png)
Installation note
Replace hexagon nut. Only tighten when rear axle shaft is horizontal. Tightening torque 120 Nm. Torque wrench 001 589 66 21 00.
11. Remove spring link.
A. Replacement of rubber mount on model 201
12. Using extractor/pulling-in equipment (06) 201 589 03 43 00, pull rubber mount out of spring link (6).
Installation note
Coat rubber mount (6b) with lubricant and using extractor/pulling-in equipment (06) 201 589 03 43 00 draw into spring link (6). Both ends of the
rubber mount must be the same distance from the spring link bush.
B. Replacement of rubber mount on model 124
