300CE (124.051) L6-3.0L (104.980) (1990)
/l6-3.0l_(104.980)/Page-2310006.png)
13. Using extractor/pressing-in equipment (06a-06b) 129 589 O1 43 00 press rubber mount (6b) out of spring link.
Note:
In order to be able to press out accurately rubber mounts (6b) which are a tight fit, it is recommended that a small projection of the rubber
mount up to the spring link bush is pressed out first using a flat thrust washer (06x).
Installation note
Replace rubber mount. Using the extractor/pressing-in equipment (06a-06b) 129 589 O1 43 00, press rubber mount (6b) into spring link. Both ends of
the steel-cased sleeve must be the same distance from the spring link bush.
14. Install in reverse sequence.
