300CE (124.051) L6-3.0L (104.980) (1990)
/l6-3.0l_(104.980)/Page-2325008.png)
21 Connect pressure oil line (B1).
22 Use new sealing rings. Tightening torque of hollow screw 25-30 Nm.
Note: Pay attention to perfect hose installation of all hoses.
23 Mount V-belt and tension.
24 Insert filter element or steadying plate into fluid reservoir, mount compression spring with locking spring or plastic sleeve and hex. nut.
25 Fill specified oil into fluid reservoir. Top-up oil with engine running.
26 Turn steering several times completely to the left and right to vent the system.
Check oil level and power steering system for leaks. See: Service and Repair
Note: With cold oil, the oil level should be 6-8 mm below mark.
28 Install ignition distributor on engines 116, 117. On engines with air-conditioning or automatic climate control, tension V-belt of refrigerant
compressor.
29 Set firing point.
30 Tighten holder of suction line (A) on cylinder crankcase.
