300CE (124.051) L6-3.0L (104.980) (1990)
/l6-3.0l_(104.980)/Page-1811003.png)
10 select parking lock.
11 Unscrew twelve point collared nut (62) and pull off propeller flange (64) or internal gear (64a).
Installation Note
Tightening torque 120 Nm, then knock collar into depression on drive shaft (arrow) using a suitable drill.
12 Remove washer (65).
13 Unscrew combined bolts and washers (71) and pull off rear cover (70) or adapter housing.
CAUTION:
When removing the rear cover (70) or adapter housing. ensure that the kickdown solenoid valve is not damaged. If necessary, slacken the kickdown
solenoid valve and rotate a little.
Installation Note
Check gasket for damage. Generally, it may be used several times but must not be coated with sealing compound. Screw in combined bolts with
washers (71) and tighten to 13 Nm (8.8) or 28 Nm (10.9).
NOTE: Degrease bolts and coat with non-hardening sealing compound.
Dismantling and Assembling
14 Press out radial sealing ring (66) using a screwdriver.
Installation Note
