300CE (124.052) L6-3.2L (104.992) (1993)
/l6-3.2l_(104.992)/Page-585002.png)
Figure 2
6.
Install heat shield (B, Figure 2) over block heater using two M6x15 mm screws and spring washers in the existing bores in the engine block.
A.Engine block heater
B.Heat shield
(Figure 2 shows model with idler arm)
Figure 3
7.
Route and fasten the cable harness along the transmission cooler line using cable ties (arrows, Figure 3).
(Figure 3 shows model with idler arm)
8.
Close coolant drain plug.
Tightening torque: 30 Nm.
9.
Reinstall lower engine panel.
10.
Lower vehicle.
11.
Route cable plug to a convenient location as per customer preference. Secure cable and plug with cable ties.
Note:
Ensure that cable is routed away from moving engine parts and sources of high heat.
