300CE (124.052) L6-3.2L (104.992) (1993)
14.
Replace receiver/drier (SMS, Job No. 83-540).
15.
Evacuate and recharge A/C system. Run engine at idle for approximately four minutes and check for proper function and leaks (SMS, Job No.
83-508).
D. Engines 104/111
Model 202
1.
Reclaim and recycle A/C refrigerant.
2.
Remove lower engine compartment encapsulation panel.
3.
Release tension and remove poly-V-belt.
4.
Remove bolt (5, engine 104 only).
5.
Disconnect 3-pole connector (A9X1) on A/C compressor.
6.
Remove bolts (3). Tightening torque: 23 Nm.
7.
Remove A/C compressor, with suction and discharge lines attached, downwards.
8.
Remove suction and discharge lines from manifold. Tightening torque: 23 Nm.
9
Remove manifold. Remove shipping plate from remanufactured unit only after releasing pressure via the schrader valve. Install manifold and new
O-rings onto remanufactured unit.
10.
Correct oil level in compressor (compensate for oil loss if additional components were replaced).
11.
Reinstall in reverse sequence.
Note:
If clutch must also be replaced, see section H.