300E 4MATIC (124.230) L6-3.0L (103.985) (1990)
10. Unbolt front axle shafts (59). Operate the footbrake in order to slacken the six bolts.
Installation note: Replace self locking bolts. Pay attention to tightening torque.
11. Push front axle shaft (59) together as far as possible and fix in this position with wire. Place axle shafts down on the wishbone.
Caution: Do not pull inner joint too far apart, otherwise rollers may fall out!
12 Unplug connector (arrow) of the oil level sensor on the left at oil sump and at front axle housing, respectively.
13 Unscrew bolts for bottom section of oil sump (4) and take off bottom section of sump (4).
Installation note: Tightening torque 10 Nm.