300E 4MATIC (124.230) L6-3.0L (103.985) (1990)
/l6-3.0l_(103.985)/Page-2262003.png)
3. The steering must self-center correctly when driving straight ahead on a test drive.
On steering gears 765.900 (model 201 up to vehicle chassis end no. A 084024) the clamping bush (83) must be detached to adjust the friction
moment. After adjusting the friction moment, push the clamping bush (83) onto the steering shaft so that both surfaces are parallel to the mounting
points of the steering gear and the milled section points towards the pitman arm (arrow).
Push on support ring (84) and tighten the nut (85) to 50 Nm.
On steering gears 765.922 and 765.950 (model 202), the sleeve (23j) with two surfaces be detached from the steering shaft.
After adjusting the friction moment first
-
align the clamping slot of the sleeve (23j) of the marking notch of the steering shaft, then...
-
push on sleeve (23j) up to the stop on the steering shaft and secure with new locking ring (23j).
Checking and Adjusting Friction Torque of Steering Gear
Removing and Installing Parameter Steering (PML) P-Valve (Y10)
Removing and Installing Parameter Steering (PML) P-Valve (Y10)
