300E 4MATIC (124.230) L6-3.0L (103.985) (1990)
/l6-3.0l_(103.985)/Page-2287004.png)
Installation note
Replace self-locking hexagon nut. Clean conical seat of ball pin in wheel carrier, press ball pin securely into taper and tighten self-locking hexagon
nut. Steady ball pin using hexagon socket wrench (04a), tightening torque 35 Nm. Torque wrench 001 589 66 21 00.
14. Mark position of eccentric bolt (40) to rear axle bracket (1) (arrow).
15. Unscrew salt-locking hexagon nut of tie rod at rear axle bracket and remove complete.
Installation note
Replace self-locking hexagon nut. Tightening torque 70 Nm. Torque wrench 001 589 66 21 00
16. Unscrew self-locking hexagon nut of torque arm (5) on wheel carrier and remove with washer, shaped washer (5b) and hexagon bolt (5a).
17. Press tensioning sleeve out of wheel
Installation note
Replace self-locking hexagon nut. Only tighten when rear axle shaft is horizontal. Tightening torque 45 Nm. Torque wrench 001 589 66 21 00.
18. Remove spring link (6) at wheel carrier, refer to Control Arm - Service and Repair - Procedures See: Control Arm/Service and Repair
Installation note
Replace self-locking hexagon nut (6f). Only tighten when rear axle shaft is horizontal. When installing the spring link, do not damage the cup seal of
the supporting joint. Tightening torque 120 Nm. Torque wrench 001 589 66 21 00.
19. Detach complete wheel carrier from rear axle shaft and remove.
20. Replace supporting joint (35-116).
21. Check toe-in and adjust if required, refer to Alignment - Service and Repair - Procedures See: Alignment/Service and Repair
22. Install in reverse sequence.
