300E 4MATIC (124.230) L6-3.0L (103.985) (1990)
/l6-3.0l_(103.985)/Page-1828002.png)
3 Remove propeller shaft (70) on transfer case. Renew self-locking hex. nuts. Tightening torque 45 Nm.
4 Unscrew sliding flange from connecting flange on front axle housing.
Note: Apply counterhold to connecting flange with open-end wrench WAF 55x65 140 589 00 01 00. Slide back unscrewed sliding flange by max.
15 mm only, to prevent any loosening from splining. If installation is offset, the propeller shaft is no longer balanced (mark the relative position of
the components, if necessary).
Installation note: Renew self-locking hex. socket screws, tightening torque 30 Nm.
5 Remove front propeller shaft (70).
