300SD (126.120) L5-3.0L DSL Turbo (617.951) (1982)
/l5-3.0l_dsl_turbo_(617.951)/Page-821003.png)
6 Loosen propeller shaft clamping nut for approx. two turns without sliding back rubber sleeve (sliding along). Tightening torque 30 - 40 Nm, while
paying allention to correct seat of rubber sleeve.
7 Remove front propeller shaft from transmission (arrows).
Note: Flexible coupling remains on propeller shaft.
Installation note: Renew self-locking hex. nuts. Tightening torque: M10 = 45 Nm, M12 = 65 Nm.
Use washers with dimensions 10.5x25x1 (on models 126.02 only and on models 126.032/033 up to 08180).
