300SD (140.134) L6-3.5L DSL Turbo (603.971) (1993)
4.
Remove eccentric bolts (19 and 20). Always use new nuts (19b and 20b) during reassembly.
Note:
The eccentric bolt nuts should only be retightened when the weight of the vehicle is resting on the front wheels.
Tightening torque: 150 N-m.
5.
Pull the control arm free from the crossmember and hold it down with a spacer block made for this purpose (013, Figure 6).
6.
Drive the aluminum end washer from the rear rubber bushing with a suitable tool (Figure 7).