300SD (140.134) L6-3.5L DSL Turbo (603.971) (1993)
Front Door Window Glass: Service and Repair
Preliminary work:
Door liner removed. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Removal and
Replacement
Exterior mirror removed.
Exterior molding with sealing bar on belt line removed.
Crank window (1)
open until screws (2) on window lift bar are accessible through installation opening at bottom.
Screws (2) on window lift bar
screw out (3 each), use Torx wrench attachment T30.
Crank window (1)
remove upward out of door shaft while tipping window toward front.
Crank window (1)
insert into door shaft from outside while tipping window toward front, guide into window guide channels at front and rear and insert into mounting
hooks on window lift bar.
Screw (2)
on window lift bar, screw in and tighten hand-tight.
Sealing channels and molding on door shaft
install.
Crank window (1)
close.
Crank window adjustment
check, readjust if required.
Screw (2)
tighten.
Exterior mirror
install.