300SE (140.032) L6-3.2L (104.990) (1992)
/l6-3.2l_(104.990)/Page-646002.png)
-
Tightening angle: 90-100°
5. Tighten conrod bolts with tightening angle wrench. Pay attention to tightening torques.
CAUTION:
^
The conrod bolts differ in weight.
^
Only identical conrod bolts may be installed in an engine.
NOTE: If no tightening angle wrench is available, the conned bolt can be tightened further with a socket wrench and tommy bar by the specified
angle in a single tightening operation. A flex-rod torque wrench must not be used for tightening to degrees of angle in order to avoid angle errors.
