300SE (140.032) L6-3.2L (104.990) (1992)
1
Heat shield
602 200 00 94
1
Screw (M6X15)
000933 006102
2
Spring washer
000137 006204
As needed
Cable tie
Local purchase
Suggested Time Allowance Information
Note:
The subsequent installation of a block heater in the model listed below is at the customer's expense.
Additional time for "Engine compartment panel(s) - bottom, R & R" (see Time Guide microfiche, group no. 61) may be applied, provided it is not
already included in another repair or maintenance service with the same repair date.
Operation: Block heater, subsequent installation
Operation Number
Time
Model
20-5480
1.4hrs.
A1, B1, B2
B. Models 140.042/043/051/070 (With Engine 119)
1.
Lift vehicle and remove left front wheel.
2.
Remove front and rear encapsulation panel from below engine.
3.
Drain engine coolant at drain plug on left side of engine block. Drain coolant into a suitable container for reuse later.
4.
Remove poly-V-belt from compressor pulley. Remove A/C compressor mounting screws and move compressor forward, without disconnecting
compressor hoses.
5.
Remove core plug (arrow, Figure 4) with a 22 mm 6-point socket. To do so, insert socket only into core plug. From wheelwell, insert socket
wrench extension through opening between sub-frame and body, subsequently engaging extension in socket. Remove core plug.