mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Low Oil Level Lamp Comes ON, Oil Level OK|Page 2675 > < Low Oil Level Lamp Comes ON, Oil Level OK|Page 2673
Page 1
background image

Oil Level Sensor: Description and Operation

Function of Electrical Oil Level Indicator:

General

The electrical oil level indicator monitors the engine oil level in the pan when the engine is running and when the engine oil temperature is above 60°
C. If the ignition is switched on, the indicator lamp comes on and goes out as soon as the engine has started.

Function 

The engine oil in the engine or level sensor (S43) is matched to the engine oil level in the pan through the drain drilling (c). if the engine oil is at the
correct level, the contact (arrow) is closed by the float (6) with a solenoid (7) and a permanent input signal (vehicle ground) is supplied to
micro-processor (a) in the electrical base plate of the instrument panel unit (1).

If the engine oil level is too low, the float (6) moves down and opens the contact (arrow). The input signal is thus interrupted and after 60 seconds
(switching delay controlled by micro-processor (a) in instrument panel unit) the oil level indicator lamp (e) comes on. If the engine oil level is too low
or if the wiring has an open circuit, the oil level indicator lamp (e) remains on after the engine has started. The drain drilling (c) is opened by the
bi-metal snap plate (8) as from an engine oil temperature of 60° C and the engine oil level in the oil level sensor is matched to that in the pan. A delay
circuit of about 60 seconds is integrated in the electrical base plate of the instrument panel unit (1) in order to prevent the oil level warning lamp
lighting up briefly when the oil is at the correct level and e.g. when cornering test.

NOTE:
^

Changing engine oil below 60° C the engine oil is viscous and only flows back slowly into the pan. (i. e. the oil level measured below 60° C
does not correspond to the actual quantity of oil in the system.)

^

When changing the engine oil, the oil level sensor (S43) is filled through the vent drilling (d) as the drain drilling (c) closes at approximately
30° C as a result of the cold engine oil.

Low Oil Level Lamp Comes ON, Oil Level OK|Page 2675 > < Low Oil Level Lamp Comes ON, Oil Level OK|Page 2673