300SE (140.032) L6-3.2L (104.990) (1992)
/l6-3.2l_(104.990)/Page-791003.png)
Engine 104.99: Unbolt camshaft sprocket of exhaust camshaft.
Take off camshaft sprocket (13) and positioning piston (14). Unscrew bolts (15 and 15a) and take flanged shaft (16) of inlet camshaft (22).
Installation
1. Fit flanged shaft (16) onto camshaft (22). Pay attention to locating pin (21), screw on.
CAUTION: Matching of securing bolt of flanged shaft to camshaft flange (see table below).
2. Fit positioning piston (14) onto flanged shaft (16) into specified position, turning to the left.
-
Hold up timing chain when performing this step.
3. Fit camshaft sprocket (13) onto positioning piston (14) in specified position, turning to the right: hold up timing chain when performing this step.
4. Fit on cover with ring (12) and screw on nut (6), but do not tighten finally at this stage.
5. Engine 104.99: Install camshaft sprocket of exhaust camshaft (see table below).
