300SE (140.032) L6-3.2L (104.990) (1992)
/l6-3.2l_(104.990)/Page-2321014.png)
2.
Remove snap ring (arrow) and knock pulley off of compressor shaft using plastic hammer.
3.
Remove screws (arrows) on housing. Open housing and disconnect blue lead.
4.
Disconnect ground cable for clutch from compressor.
5.
Remove snap ring and remove coil.
6.
Reinstall in reverse sequence.
7.
Ensure that the coil is positioned on the locating pin and the conical surface of the snap ring securing the coil is facing out.
