300SL (129.061) L6-3.0L (104.981) (1991)
/l6-3.0l_(104.981)/Page-2932003.png)
CAUTION!
Only the modified washer pump as noted in the Parts Information table below is to be installed on all vehicles as listed in the Effective Serial
Number Range table. Verify modified headlamp washer pump by observing correct part number embossed on the pump housing.
9.
Remove the large rubber grommet from the washer reservoir.
10.
Prior to installing the modified headlamp washer pump, replace the large rubber grommet as removed in step 9.
11.
Reinstallation is in reverse order.
12.
Refill windshield/headlamp washer reservoir.
13.
Reconnect battery ground cable.
14.
Check function of washer system. Verify that the headlamp washer pump runs with the ignition ON, headlamps ON and upon activation of the
washer switch.
15.
Check and adjust as necessary, both headlamp wiper arms.
Refer to Diagnostic Directory 4, Group 82, Topic number 82T92092.
16.
After completion of the campaign, write the recall number 96-1113 and dealer code on the appropriate location on the recall sticker
(LZ-2605-093) and affix the recall sticker to the driver's door A-Pillar.
Parts Information
Warranty Claim Submission Information
Operation:
Remove windshield/headlamp washer reservoir. Replace headlamp washer pump with modified headlamp washer pump. Check function of washer
system with ignition ON and headlamps ON, and activation of the washer system. Check and adjust headlamp wiper arms, as necessary.
(Repair Code 11)
