300TD (123.193) L5-3.0L DSL Turbo (617.952) (1984)
/l5-3.0l_dsl_turbo_(617.952)/Page-1183003.png)
16. Turn ignition key to position "0". Disconnect battery negative terminal and cover.
17. Disconnect red 10-pin plug connection (arrow).
21. Tie string to red 10-pin plug of control unit and route connecting cable through the front wall pillar with the aid of this string.
18. Test system with tester, See "Test Instructions for Tester...", which is contained within the article at "Test Program, Air Bag and Belt Tensioner
(up to 09/87) and Air Bag 1/3, Tests". See: Testing and Inspection/Component Tests and General Diagnostics
NOTE: Test steps 2, 6 and 7 found under "Test Instructions for Tester..." are no longer required with the installation of air bag 1/3.
19. Continue installation in the reverse sequence.
20. Check system with RS warning lamp.
-
Connect test coupling/plug connection, airbag, 10-pin (X29/9).
-
Switch on ignition. The RS or SRS warning lamp must go out after approx. 4 s.
NOTE: After the installation of a modified airbag control unit (airbag 1/3) part no. 004 820 11 10 supplementary jobs will be necessary:
Table
1. In addition to modified control unit install either line A or line B (table) depending on which control unit was installed in the vehicle.
2. Additional Work:
