300TE 4MATIC (124.290) L6-3.0L (103.985) (1991)
/l6-3.0l_(103.985)/Page-2628001.png)
Trunk / Liftgate Shock / Support: Service and Repair
Removal and installation of gas pressure spring on back door
Remove trim on rear roof frame, refer to Body and Frame/Interior Trim/Service and Repair See: Interior Moulding / Trim/Service and Repair
1. Remove safety clip
2. Push bolt out
3. Unbend sheet metal lock and pull out bolt by means of pliers, remove in forward direction (pay attention to installation note)
8. Protect back door with support and disengage headlining in lateral direction
Installation note: When installing the gas pressure spring, make sure that the rubber sleeve is placed over cylinder of gas pressure spring. For
easier assembly, coat rubber sleeve with soap solution.
