300TE 4MATIC (124.290) L6-3.0L (103.985) (1991)
Technical Service Bulletin # WORK265
Date: 911102
Electrical - Connector Block For Accessory Equipment
Group:
54
Number:
265
Work Instructions
Date: November 1991
SUBJECT:
MODEL 126 WITHOUT HEATED SEATS INSTALLATION OF CONNECTOR BLOCK FOR ACCESSORY EQUIPMENT
(X30)
Figure 1
Model 126 vehicles without heated seats are not equipped with the connector block for accessory equipment (X30, Figure 1).
This connector block should be installed prior to installing any aftermarket electrical equipment. It is the best method of supplying a source for circuits
30, 15, 15R, 58d and 31 (up to approx. 5 amps) while maintaining vehicle wiring integrity.
Procedure
1.
Disconnect and cover battery negative terminal.
2.
Remove left front floor mat/carpeting.
3.
Remove cover on left front rocker panel.
4.
Remove both covers under left side of instrument panel.
5.
Remove cover on lower area of left A-pillar.
6.
Remove left knee bolster.
7.
Remove air hoses for left air vent, defroster vent and door vent.
8.
Remove accelerator pedal.