350SDL (126.135) L6-3.5L DSL Turbo (603.970) (1990)
-
Remove cap (1).
-
Unscrew screw (2). Tighten to 35 Nm on re-installation.
-
Release sill trims.
-
Remove screws (3) in trim (4).
-
Remove trim (4).
-
Pull cladding panel (5) on center pillar out downwards.
-
Pull belt strap with latching tongue through cutout in cladding.
-
Remove screw (6) in belt guide fitting. Tighten to 35 Nm on re-installation.
-
Remove screw (7) in inertia reel. Tighten to 35 Nm on re-installation.
-
Disconnect plug connector (8) of belt tensioner ignition pellet..
-
Remove belt tensioner from the center pillar.
-
Pull trim on passive anchorage fitting rearwards and to the side, and remove.
-
Remove screw (9) in belt lock.
-
Release cable ties under seat cushion.
-
Remove belt lock, with lead.
Installation is the reverse of the removal procedure.