380SEC (126.043) V8-3.8L (116.963) (1982)
3
Remove end cover.
A threaded hole M 8 is provided on each side to facilitate removal of a tightly seated end cover (arrows).
Installing:
4
Carefully clean sealing surfaces at crankcase and at closing cover.
5
Apply an even coat of sealant to sealing surface of closing cover, ensuring that no sealant gets into the oil circuit.
6
Fill radial seal with engine oil between dust and sealing lips.
7
Push closing cover with radial seal over the screwed-in insertion tool and screw on.
NOTE: Pay attention to different bolt lengths.