380SEC (126.043) V8-3.8L (116.963) (1982)
Ride Height Sensor: Service and Repair
Removal and Installation of Control Rod
R AND R LEVEL CONTROLLER LINK
Note
After exchanging connecting rod, readjust vehicle level on rear axle again under load.
Removal
1
Unscrew hex. nuts of connecting rod (7) on lever of level controller and on lever of torsion bar.
If required, hold ball pin joints in plastic bearings with open-end wrench 10 mm or ball pin of steel joints with an angle screwdriver.
2
Check ball joints of connecting rod for easy operation and wear.