400E (124.034) V8-4.2L (119.975) (1992)
On this model the oil reservoir (35) is attached to a support (1a) which is screwed to the tandem pump (1).
Loosen hose clamp, disconnect hose (arrow) and set aside. Unscrew bolts (46) and remove tandem pump (1) from support (1a).
Unscrew bolts (arrow, 4 bolts). Remove end cover (2k), check O-ring (2g), replace if required. Work steps numbers 1-3 in "Work Steps" are
omitted.
Work Steps
Work Steps
CAUTION: Before proceeding, see Important Notes.* On certain models work steps 1-3 below are omitted and replaced by the steps found in
"Important Notes." See: Tandem Pump (TANP) Models 67, 167/Disassemble/Important Notes
NOTE:
For application identification refer to "Steering : Power Steering Pump : Service and Repair : Overhaul Procedures : Application and ID" See:
Application and ID
Disassembling:
1.* Screw down vent cap (35c). remove end cover (35d).