420SEL (126.035) V8-4.2L (116.965) (1986)
6 Loosen propeller shaft clamping nut for approx. two turns without sliding back rubber sleeve (sliding along). Tightening torque 30 - 40 Nm, while
paying allention to correct seat of rubber sleeve.
7 Remove front propeller shaft from transmission (arrows).
Note: Flexible coupling remains on propeller shaft.
Installation note: Renew self-locking hex. nuts. Tightening torque: M10 = 45 Nm, M12 = 65 Nm.
Use washers with dimensions 10.5x25x1 (on models 126.02 only and on models 126.032/033 up to 08180).