500SEC (140.070) V8-5.0L (119.970) (1993)
/v8-5.0l_(119.970)/Page-746002.png)
-
Insert jaws for duplex roller chain with number 1 into fitting tool and screw on with screw (28) (Fig. E).
-
Insert moving thrust piece (arrow) for simplex roller chain with number 2 into fitting tool (Fig. F).
-
Insert outer plate (8) (thickness 1.2 mm) into moving thrust piece (Fig. G).
-
Fit webs (arrows) onto roller at riveted link.
-
Screw in spindle (06) until tight resistance is felt.
NOTE: When screwing in, ensure that the pins of the riveted link are inserted into the holes of the outer plate (8).
-
Remove insertion tool.
-
Turn over moving thrust piece (arrow) with number 2 (riveted section) (Fig. 1).
-
Position fitting tool exactly over center of pin (Fig. J).
-
Tighten spindle (06) to: 30 Nm (Fig. J).
-
Rivet pins of riveted link (6) individually (Fig. J).
-
Examine riveting (arrows), re-rivet if necessary (Fig. K).
-
Set basic position of camshafts, refer to Set Basic Camshaft Timing. See: Camshaft, Lifters and Push Rods/Camshaft/Testing and Inspection
-
Install chain tensioner.
-
Check basic position of camshafts.
