500SEC (140.070) V8-5.0L (119.970) (1993)
/v8-5.0l_(119.970)/Page-2955003.png)
4.
Remove eccentric bolts (19 and 20). Always use new nuts (19b and 20b) during reassembly.
Note:
The eccentric bolt nuts should only be retightened when the weight of the vehicle is resting on the front wheels.
Tightening torque: 150 N-m.
5.
Pull the control arm free from the crossmember and hold it down with a spacer block made for this purpose (013, Figure 6).
6.
Drive the aluminum end washer from the rear rubber bushing with a suitable tool (Figure 7).
