500SEC (140.070) V8-5.0L (119.970) (1993)
Connect the Impulse counter (013) and adapter (075) according to connection diagram. LED "U-Batt" must light up.
EXTRACTING CODES
1. Turn ignition "ON".
2. Press start button for 2 - 4 seconds.
3. Read and record fault code (DTC).
4. Press start button again for 2 - 4 seconds.
5. Read and record fault code (DTC).
6. Repeat steps 4 and 5 until the first fault code reappears.
CLEARING FAULT CODE AND SELF-ADOPTION MEMORY
1. Press start button for 2 - 4 seconds.
2. Read fault code.
3. Press start button for 6 - 8 seconds, thereby clearing the previously displayed fault code.
4. Repeat steps 1 - 3 until fault code "1" appears (no faults stored).
5. After fault code "1" appears on the display, press start button for 6 - 8 seconds.