500SEC (140.070) V8-5.0L (119.970) (1993)
/v8-5.0l_(119.970)/Page-1678003.png)
Preparation
-
Transmission removed.
Procedure
-
Rotate engine so that no segments (arrows) of the ring gear (20) are touching the bracket (1).
-
Take off ring gear(20), fit on
Tighten to: 5 Nm.
Pay attention to installation position (see note).
Specification Data Table
-
Permissible variation from concentricity at ring gear: 0.30 mm
-
Centering collar diameter for driven plate (1.5 mm thick): 296.00 - 296.05 mm
NOTE:
-
Driven plates and ring gear are balanced individually; they may be replaced without being balanced.
-
The ring gear must be installed so that the 3.5 mm dia. holes (arrows) in the ring gear (20) and in the driven plates (18) have the same angular
position otherwise proper operation of the ignition is not assured.
RA03001195000X Remove/Install Retaining Lock For Crankshaft/Ring Gear
RA03001195000X Remove/Install Retaining Lock For Crankshaft/Ring Gear
Transmission Installed:
