500SL (129.067) V8-5.0L (119.972) (1993)
Distributor Shaft: Service and Repair
-
Remove and install intake air hose.
-
Model 124: remove and install air scoops.
-
Unclip and take off shielding caps (1) and (1a) at the side.
-
Unbolt high voltage distributors (2) and (2a).
-
Unbolt distributor rotor (3). Tighten to 2.5 Nm on reassembly.
-
Unbolt driver (4). Tighten to 9 Nm on reassembly
Installation Note: The slot of the driver (4) must engage in the locating pin in the camshaft.
-
Take off protective cover (5) together with seal (6).
-
Installation is reverse of removal procedure. Observe installation note and tightening torques.