600SEL (140.057) V12-6.0L (120.980) (1993)
Sunroof / Moonroof Cable: Adjustments
-
Press tilting/sliding roof switch to "roof up", until tilting/sliding roof panel is completely lifted.
-
Move adjustment knob (Fig. 4) to adjustment position, pull out against stop and then press in approx. 3 mm.
-
Turn adjustment knob (Fig. 5) until centering bolt (shop-made) can be inserted completely through the hole in the mounting plate into the control
unit behind and the notch on the adjustment knob points in the direction of the hole.
-
Press adjustment knob in and remove centering bolt.
CAUTION: When the centering bolt is inserted or the adjustment knob is pulled out DO NOT actuate the tilting/sliding roof motor. The control
unit can be damaged or the adjustment lost.
-
Check closing operation, if required move adjustment knob back into adjustment position and perform fine adjustment by turning knob.
Turning knob to right = sliding roof forward.
Turning knob to left = sliding roof back.
NOTE: One rotation of the knob changes the position of the tilting/sliding roof by approx. 45 mm.
-
Press adjustment knob in and actuate tilting/sliding roof switch.
-
Reinstall panelling in trunk.
-
Reinstall headliner.
Shop Made Tool - Centering Bolt