600SEL (140.057) V12-6.0L (120.980) (1993)
Sunroof / Moonroof Panel: Adjustments
Tilting/Sliding Roof Panel Adjustment
-
Remove headliner on tilting/sliding roof.
-
Raise tilting/sliding roof.
-
Loosen screws (Fig. 2).
NOTE: On the glass tilting/sliding roof the rubber bellows on the tilting/sliding roof panel must be detached. See "Service and Repair" figures 1b and
2b.
-
Lower tilting/sliding roof.
-
Insert centering bolt (shop-made) into centering hole (Fig. 1).
Height adjustment at front = 0 to 1 mm lower than roof panelling.
Height adjustment at rear = 0 to 1 mm higher than roof panelling.
-
Tighten screws.
-
Remove centering bolt.
NOTE: After closing from sliding position check adjustment at points "A" = 140 mm (Fig. 3).
-
Continue to reinstall in opposite order.
Centering bolts (2 each)