600SEL (140.057) V12-6.0L (120.980) (1993)
Part 3 Of 3
Removal
NOTE:
^
Refer to Notes On Brake Fluid.
^
Refer to Notes on Test and Repair Work to brake system.
1. Ignition OFF.
2. Disconnect hydraulic lines.
-
Seal hydraulic lines and connections with blind plugs.
CAUTION: Do not transpose lines.
3. Remove hydraulic unit.
-Model 170, pull upward out of the rubber plugs.
Installation
Reverse procedure to install, noting the following:
-
Install plastic caps with lugs downward.
-
Tighten lines to hydraulic unit to: 15 Nm
-
Bleed brake system. See: Brake Bleeding/Service and Repair
-
Read and clear any Diagnostic Trouble Codes (DTC)s.