600SEL (140.057) V12-6.0L (120.980) (1993)
7.
Remove the rear solid rubber bushing with remover/installer, special tool no. 140 589 11 43 00, (012, Figure 8).
CAUTION! Do not use an impact wrench to remove or install the hydraulic bushing.
Special tool note:
Use remover/installer, special tool no. 140 589 11 43 00, for removal and installation of the control arm bushings.
The previous remover/installer, special tool no. 140 589 03 43 00, can still be used when equipped with update kit, special tool no. 140 589 11 43 25.
See S.I. MBNA 33/5, 58/56 (July 1992) for complete information on use of this tool.
8.
Coat hydraulic bushing with a thin layer of installation lubricant, part no. 001 989 14 51, and install into control arm with the offset indentation
(arrows, Figures 9 and 10) horizontally aligned with the welding seam of the control arm, pointing toward the ball joint/outside of the vehicle (A,
Figure 10).
CAUTION!