600SEL (140.057) V12-6.0L (120.980) (1993)
32. Carefully insert drive shaft (11) together with bearing flange (14) into the housing (do not damage seal). Ensure that the groove for the roll pin
(19) is parallel to the roll pin bore. Knock roll pin (19) into the housing.
33. Insert spring (38) and piston (37) into the screw cartridges (40).
Piston and housing must always be matched to each other.
34. Screw all 4 screw cartridges (40) into the housing in the consecutively numbered order shown in number 10, 40 ± 5 Nm. Use pronged wrench 129
589 02 07 00.
35. Insert thrust washer (5) and O-ring (22) into the housing. Bronze-coated side of the thrust washer (5) must be installed facing the rotor.