600SEL (140.057) V12-6.0L (120.980) (1993)
13.
The inside edge of the rear fenders must be rebent to an angle of 110° over the complete wheel cutout (A, Figure 9) to accommodate the wider
wheels and tires.
14.
Grind off any excess PVC underbody protection before rebending the fender lip.
15.
Use a hot air gun to carefully heat up the outer edge of the fender to 158 - 176 °F (70 - 80 °C).
Note:
Do not overheat paint while applying heat.
16.
The tender lip is reworked over the entire area (A, Figure 9) in several stages. A plastic hammer must be used to avoid damaging the paint.
17.
Install new wheel/tire combination.
! WARNING!
Only the M12 x 1.5 x 40 mm spherical wheel bolts supplied with the rims are to be used.
18.
Evenly tighten wheel bolts to 110 Nm.
! WARNING!
AMG light alloy wheel bolts must be retightened after 60 - 300 miles (100 - 500 km). Tightening torque: 110 Nm.
B.
AMG LIGHT ALLOY WHEEL, 7-1/2 J x 16 H 2 ET 31
Front lenders