600SEL (140.057) V12-6.0L (120.980) (1993)
Rear Door Window Glass: Adjustments
Preliminary work:
Door liner on rear door removed.
Vapor seal on interior door panel
pull off.
Crank window
close and check clearance at top between window guide channel and outer edge of window with 0.3 mm feeler gauge.
Adjustment
correct with stop at top of interior door panel, figure 2.
Lateral clearance
measure with window closed. Nominal value: 0.3 mm.
Adjustment
correct on window stay.
Covering on inside of window stay
remove.
Door sealing frame
pull out of channel in area of window stay, top.
Screws at top and bottom of window stay
loosen, figure 3.
Window stay
adjust so that vertical clearance between window guide channel and outer edge of glass is 0.3 mm at front and rear.
Screws at top and bottom of window stay
tighten.
Door sealing frame
install.
Screws on inside of window stay
(3 each) loosen.
Cover on stationary window
press toward rear and tighten screws.
Interior covering on window stay
install.
Slider on window lift bar
lubricate, use MB paste lubricant part number 000 989 31 51.
Door liner on rear door
install
Function