600SEL (140.057) V12-6.0L (120.980) (1993)
1
After expiration of the heat-up time remove glue cartridge from cartridge heater, remove bottom of cartridge and puncture diaphragm. Screw on
application nozzle and insert cartridge into cartridge gun.
NOTE: Heat-up time at least 20 minutes.
2
Guide nozzle along adhesive surface or glue residue on body flange while pressing a uniform quantity of glue out of the glue cartridge.
NOTE: Height of glue bead approx. 13 mm.
NOTE: Install windshield within 5 minutes before adhesive force of glue begins to decrease.
Aligning Windshield In Body Opening
References (BE), Test and adjustment values for windshield
Figure 1
1
Before applying glue to windshield position on rubber windshield spacers and center
NOTE: Observe dimension "A" measured between top of windshield and front edge of roof.
NOTE: The distance from the side edge to the clip must be large enough to install the molding without damaging the windshield.
2
Glue on strips of tape (arrows), cut through at top of windshield and remove windshield.
3
Remove protective foil from retaining strips
Installing Windshield