C 230 (203.040) L4-1.8L SC (271.948) (2005)
Center Mounted Brake Lamp: Service and Repair
AR82.10-P-5375P Remove/Install Center High-Mounted Stop Lamp
Shown On Model 203.0
1
Remove paneling from inside of trunk
2
Unscrew bolts from the retaining clamps of the center high-mounted stop lamp (E21)
3
Push center high-mounted stop lamp (E21) out of trunk lid
4
Disconnect connector of center high-mounted stop lamp (E21x1)
5
Remove retaining clamps (1)
6
Screw retaining clamps (1) to center high-mounted stop lamp (E21)
NOTE: When replacing center high-mounted stop lamp it is supplied with new clamps
7
Attach connector of center high-mounted stop lamp (E21x1)
8
Insert center high-mounted stop lamp(E21)
CAUTION:
-
Ensure that seal is in good condition and properly seated Apply sliding compound
-
Do not allow retaining clamps to damage paintwork.
NOTE: Ensure that retaining brackets are correctly seated. Retaining brackets must be able to be pushed together when fitted
9
Perform function check
10
Install hazard warning triangle