C 230 (203.052) V6-2.5L (272.920) (2007)
Parking Brake Cable: Service and Repair
AR42.20-P-0520P Remove/Install Front Brake Control Cable
Remove/Install Front Brake Control Cable
Shown On Model 203
Remove/Install
DANGER:
-
Lethal injuries are possible if vehicle slips off of lifting platform
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by
the vehicle manufacturer.
1
Raise vehicle with lifting platform
2
Remove cover panel below rear seat cushion
3
Loosen adjusting nut (89)
4
Detach brake cable (85) at intermediate lever (91) and detach at intermediate lever housing using snap-release tool (043)
5
Remove front left floor covering
6
Remove cover below instrument panel
7
Detach cover (71a) of parking brake pedal (75)
8
Detach brake cable (85) from parking brake pedal (75)
9
Remove heat shield of exhaust system.
10
Unclip brake cable (85) and remove
NOTE: Destroy clips that are difficult to move when removing cable.
11
Install in the reverse order
Inspecting
12
Check version of pedal assembly
13
Adjust parking brake