C 230 (203.052) V6-2.5L (272.920) (2007)
-
Ignition system
-
Injection system
-
Electronic accelerator
-
Idle speed control
-
Torque interface
-
Diagnosis and fault storage
-
Gateway between the drive CAN and the chassis CAN
-
Immobilizer and drive authorization
-
Evaporative emission control system (for (USA) with leak test)
-
Fuel supply
-
Starter control
-
Fan control
-
Secondary air injection
-
Emission control
The ME-SFI [ME] control unit is flashable. The software required to program the control units is provided on the DAS Update DVD.
The ME-SFI [ME] control unit evaluates the following basic information:
-
Air mass
-
Coolant temperature
-
Engine speed/crankshaft position
-
Smooth operation of the engine (misfire detection)
-
Throttle valve position
-
Accelerator pedal position
-
O2 sensor signals
-
Intake manifold pressure
-
Intake air temperature
-
Outside air temperature
-
Air pressure (altitude)
-
Inlet and exhaust camshaft position
-
Vehicle speed (via CAN)
-
Steering angle (via CAN)
-
Alternator interface
-
Knocking of engine
-
Brake recognition (via CAN)
-
Oil level
-
Position of the clutch pedal (for manual transmission 716.6)
GF07.61-P-6000V ME-SFI [ME] Control Unit, Component Description
GF07.61-P-6000V ME-SFI [ME] Control Unit, Component Description
Location
The ME 9.7 control unit is located on the intake manifold supporting the engine.