C 230 CL (203.740) L4-1.8L SC (271.948) (2003)
/l4-1.8l_sc_(271.948)/Page-3002001.png)
Rear Bumper: Service and Repair
AN31.11-P-8080-02PB Fabricating A Bumper Cutout
AN31.11-P-8080-02PB Fabricating A Bumper Cutout
1. Cut out opening for trailer hitch in bumper (1).
The cutout is pre-perforated on inside of bumper (1).
2. Install cover (2) in bumper (1) and transfer holes (arrow) to bumper (1).
3. Remove cover (2) and drill marked holes with 6 mm dia. bit and deburr.
4. Insert bumper (1) and ensure that the brackets (6) are inserted into the guides (5) on left and right.
Move adjustment screws (10) into retaining sheet metal plates.
