mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

AR83.25-P-1000P Remove/Install Heater Housing|Page 9478 > < AR83.25-P-1000P Remove/Install Heater Housing|Page 9476
Page 3
background image

NOTE:  Front lower section.

4

Drain coolant at radiator

5

Completely move back driver and passenger seats.

DANGER:
Completely move back driver and passenger seats. Risk of explosion from explosive gas. Risk of poisoning and caustic burns from
swallowing battery electrolyte. Risk of injury from caustic burns to eyes and skin from battery electrolyte or from handling damaged lead
acid batteries.
-

No fire, sparks, naked flames or smoking.

-

Wear acid-proof gloves, clothing and eye protection. Pour battery electrolyte only into suitable and appropriately marked containers.

6

Remove instrument panel carrier

7

Remove accelerator pedal

8

Fold back floor covering at front left

NOTE:  Air duct to left rear compartment (14) must be accessible.

9

Remove air duct to left rear compartment (14)

10

Fold back floor covering at right front

NOTE:  Air duct to right rear compartment (15) must be accessible.

11

Remove air duct to right rear compartment (15)

12

Remove drier cartridge

CAUTION:  Installation:  after the refrigerant circuit is opened replace drier cartridge. Observe additional oil quantity after replacing
parts.

13

Unscrew nut (1)
-

Nut for expansion valve:  8 N.m

14

Remove pressure lines together with retaining plate (2)

CAUTION:  Plug openings.

-

See "Special Tools" given below.

CAUTION:  Installation:  Replace O-rings (moisten with compressor oil).

15

Remove hose clamp (3) from fitting

CAUTION:  Installation:  install hose clamp (3) at angle of 45 degrees (figure A) with hose clamp pliers.

-

Hose clamp pliers (length 210 mm; adjustment range 80 mm)
See "Commercially Available Tools" given below.

16

Remove hot water feed hose (4)

CAUTION:  Plug opening.

-

See "Special Tools" given below.

17

Remove hose clamp (5) from fitting

CAUTION:  Installation:  Install hose clamp (5) at angle of 45 degrees (figure B) with hose clamp pliers.

-

Hose clamp pliers (length 210 mm; adjustment range 80 mm)
See "Commercially Available Tools" given below.

18

Remove hot water return hose (6)

CAUTION:  Plug opening.

-

See "Special Tools" given below.

AR83.25-P-1000P Remove/Install Heater Housing|Page 9478 > < AR83.25-P-1000P Remove/Install Heater Housing|Page 9476