C 280 (203.054) V6-3.0L (272.940) (2006)
-
Store airbag unit with expulsion area on top, do not subject to temperatures above 100 degrees C When working on these units, disconnect the
power supply.
5
Remove airbag unit on steering wheel
CAUTION: Instructions for performing repair, body work and welding on vehicles with airbags and ETR units
6
Unplug steering wheel heater connector (1)
7
Unscrew countersunk bolt (32c) while steadying steering wheel (32)
CAUTION: Installation: Install new countersunk bolt otherwise the old bolt may work itself loose
8
Remove steering wheel while guiding wires from airbag through the opening
NOTE: Installation: Assign the recess clearances of the serrations in the steering wheel (arrows) to the markings on the steering shaft
9
Check the clock spring contact (A45) for damage
10
Install in the reverse order
11
Activate steering angle sensor
12
Conduct a road test
-
Check during test drive
-
Flasher canceling
-
If displaced by more than 1 tooth, satisfactory resetting of the turn signal is no longer guaranteed
-
Airbag indicator lamp
-
The SRS indicator lamp must not light up with full steering angle in both directions
-
Steering wheel position
-
If the steering wheel is crooked, adjust it by max 1 tooth If the difference is greater, Check and adjust toe on front axle.