C 280 (203.054) V6-3.0L (272.940) (2006)
CAUTION: Avoid brake fluid and soiling in interior. Otherwise parts of the interior may become damaged.
11
Disconnect coupling (1) from clutch pedal switch (S40/3)
12
Press retainer (2) off pin (3)
13
Pull out pin (3)
NOTE: Installation: Lightly grease pin.
14
Unscrew collared nuts (4)
15
Remove pedal assembly
NOTE: Do not damage wiring harness.
16
Pull out line at the connecting pipe of the master cylinder
NOTE: Installation: Replace O-ring (10).
17
Pull connector hose (8) into the interior
NOTE: Installation: When installing ensure that the grommet (11) is seated correctly.
18
Install in the reverse order
NOTE: Do not install engine compartment paneling or lower part of noise encapsulation yet.
19
Bleed clutch actuation
20
Install lower engine-compartment encapsulation panel
NOTE: Only remove the rear section.
21
Install lower parts of noise encapsulation
NOTE: Only remove the rear section.