C 300 (204.054) V6-3.0L (272.947) (2008)
/v6-3.0l_(272.947)/Page-3205002.png)
See picture B.
Ensure that no other components are damaged when drilling a hole with a diameter of 5 mm.
4. Clean gluing surfaces with specified cleaning agent.
The sealing surfaces must be free of dust and grease.
5. Insert plastic rivets (3).
6. Remove protective foil on adhesive strips by pulling at gripping points (shown in magnified section).
Ensure that rear diffuser (1) remains in installation position and makes contact with contour of rear bumper (2).
Uniformly pull off protective foil.
