C 300 (204.054) V6-3.0L (272.947) (2008)
2.
Check left and right cross member for crack formation at the exterior contour at positions shown (Figure 2):
^
If crack formation at the exterior contour is not present: Procedure is complete.
6
If crack formation (Figure 3) at the exterior contour is present, proceed to step 3.
3.
MIG weld cracked rear cross member:
Note:
Ensure experienced MIG welder is performing this procedure.
^
Disconnect negative battery cable:
Refer to WIS: AR54.10-P-0003CW.
^
Drill a 1/8" hole at the end of the crack.